Hardcover Book Cover Printing: A Common Process

There are many different hardcover cover printing prices. These different costs directly impact the hardcover print cost. Printing a fine hardcover is difficult, yet it has a wide range of visual and tactile effects for the readers. It is therefore important that you are familiar with the hardcover printers in china before printing a hardcover, situs yang direkomendasikan!

Find out more about cover printing when we print hardcover books.

1. UV Coating

This process of ultraviolet curing is known as UV (Ultraviolet). The use of this glazing technology will improve both the protection and the performance of your printed matter. Partial UV coating and full-frame surfaces are both covered with the coating. By industry, “over-UV-oil” or “over oil” refers to the first type of UV coating. “Partial UV” refers to the latter. In 2003 and 2004, partial UV was used to finish books for the first time. This binding method is widely used in publishing, particularly by book publishers for the cover of books. Books for class or graphic class.

2. Laminating

The film is an adhesive plastic sheet that can be applied to the front cover to improve its shine and resistance to moisture, dirt, light or water. Films come in two different types: matt and high-gloss. The glossy film gives the book an incredibly dazzling surface. Matt films make it look simple but elegant. The bright film produces a more vivid print while the dumb film creates a darker, softer print. The price of dumb film is more expensive than bright film. It is easy to understand that sub-film prints may be seen in all directions, while bright prints must be viewed only from a certain angle. Unfortunately, the material used in the current filming process is not biodegradable and does little to protect the environment. Now 90 percent of the books have this procedure. In general, local UV coatings on book covers are done with the film.

3. Bump embossing

This is the process of “printing”, without ink. This process is known by the names embossing (also called concave embossing), embossing (also called convex, or even embossing), and embossing. It is done by using concave/convex moulds in steel or copper that are matched to the figure. For book bindings, the concave-convex technique is mostly used for printing the letter sleeves and cover text, as well as patterns or wireframes, to give the printed material a more three-dimensional impression. The embossed area can then be inked or partially UV-glazed to create text and graphics. More prominent. This technique is commonly used on book covers, hardcover or otherwise. The relief effect can be achieved in three to four stages with the hand-carving.

4. Color foil hot stamping

Hot stamping color foil is used to create a cover for a hardcover made from paper, leather, textile, wood or plastic. The heat is applied to Or patterns and wireframes so that the title can be printed in gold or silver foil, powder foil, red, blue, green, purple, yellow, orange, pink, brown, black, white, grey, or any other color. It is a beautiful way to make your hardcover books look more luxurious. This technique is used widely in the finishing of covers. In the old days, gold and sterling silver was often applied on both the front and rear of hardcovers. Now, more and more, gold and metallic silver are being used as well on the covers and backs of paperbacks. In some cases, paperbacks still feature hot-stamped and silver title pages and the ring liner. They do this because gold and/or silver printing on colored paper can have a very unique look.

5. Die cutting, indentation

It is done by using steel knives to make a die cutting plate. This then allows you to roll and cut paper and printed material into specific shapes. This machine can cut printed matter in arcs or complex shapes. It also punches the material. It can be hollowed out and processed in other ways.

Leave a Reply

Your email address will not be published. Required fields are marked *